Cassese CS940 Double Mitre Saw

The Cassese CS940 Manual Double Mitre Saw

Industry-Leading Features:

• Manual, independently controlled radial cutting stroke - for reduced wastage
• Unique “raised blade stroke” ABOVE table surface – This allows an angle of cutting towards the interior of the     moulding profile, which eliminates the possibility of chipping and bad finishing, which is unavoidable on other horizontal   blade stroke systems where the blades are mounted below the table surface.
• Compact, narrow profile (742mm wide) - for fitting through standard doorways and compact spaces.

Production Features:

• Wider cuts (140mm) and higher cuts (75mm) with standard 300mm blades - providing the straightest possible cuts on even the widest mouldings.
• Horizontal & Vertical pneumatic clamps - Twin horizontal and twin vertical clamps are integrared and adjustable to allow secure clamping of difficult mouldings, eliminating any movement or rocking during the cut cycle.
• Zero wastage – Because the blades cut with independent actions, wastage is saved at the first cut which saves both moulding and money.
• Easy-to-read 45° direct measuring scale - for faster and more accurate measuring.
• 1.2mtr support arms - Solid, robust feed-in support and feed-out measuring arm, with optional 1.0mtr extension available.
• No blocked chutes – Because offcuts fall directly into the open waste collection chute below the cut, there is no need for regular checking or cleaning of wastage chutes.
• Internal cutting support block – This supports the off-cut preventing chipping on the back edge of the chop.
• Synchronised activation of dust extractor -The dust extractor can be pre-wired to the saw, so that both units can be run and stopped simultaneously. This saves time, reduces power consumption and excessive noise.

Safety Features:

• CE approved - Satisfying the highest safety standards in the industry
• Automatic Brake System - Stops blades rotating in less than 4 seconds
• Safe and Easy Blade Access - Completely enclosed with no exposed motors or blades.
• Foot operated pneumatic clamping
• Hardened plasti-sheild window - Allows the operator to have clear visibility of the cut.
• Convenient blade-change system - When blades require changing for sharpening, they can be conveniently positioned for safe and comfortable access.
• Emergency push button cut-off switch 

Operating Requirements:

• 20A SinglepPhase power and connection by electrician • Source of compressed air (6 bars)

Options:

• Optional right-hand moulding support arm also available for a total measured cut capactity of 2.2mtrs
• Optional 1200CFM dust extraction unit available